PET Dispensing pot

PET DISPENSING POT

A simple and effective way of manually dispensing PET isotopes. This manual is produced to guide the owner / operator in the safe use of the BriTec PET Pot. The owner or operator of the equipment must read this manual carefully to gain technical understanding of the it to operating the unit.

The PET Pot has been designed specifically for drawing a dose out of an shielded vial into one of our Pet Syringe Shields while minimizing finger doses.

Total weight: 28kg.

Equipment Description

Rotating PET Pot to allow vial to be inserted for
ease of drawing dose into shielded syringe.
Removable shielded syringe sleeves to allow
you to choose the most appropriate syringe.
Removable vial sleeves to allow you to choose
the most appropriate vial.

What you’ll receive with your PET pot is:

PET Pot Stand
PET Pot Body
PET Pot Lid
PET Pot Cap
PET Pot Sleeve Holder
1ml Syringe Sleeve For Product 1BT-511S01
2/3ml Syringe Sleeve For Product 1BT-511S02/3
5ml Syringe Sleeve For Product 1BT-511S05
10ml Syringe Sleeve For Product 1BT-511S10
PET Pot Base
Various Vial Inserts
Spring For Vials

Code	Description
8BT-PETPOT1	PET dispensing pot

The PET Pot comes with a range of standard vial inserts for use with most commonly used vials. Custom vial inserts can be made to order, we recommend that you send us a sample vial so that we can ensure that the vial insert best fits your needs.

We strongly advise that no air is to be injected into the vial when using this product as this could cause increased pressure within the vial and backflow through the bleed needle. We recommend practicing on vials containing dyed water until you are comfortable and familiar with the system and its operation. Please use the guide below to help you with this. If you have any questions about the product or procedure then please contact us using the details on the back page.

This product should be used behind a shielded barrier such as our 5BT-LVB30 PET Barrier.

How to use the product

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Step 8

Step 9

Step 1

Place correct vial insert into the PET Pot, then insert vial you are using into the PET Pot.

Step 2

Place shielded lid onto PET Pot. Rotate lid anti-clockwise 45° until it locks into place.

Step 3

Fix syringe guider into place.

Step 4

Lock syringe guider onto PET pot.

Step 5

Pull out the locating pin on the left hand side of the stand. Rotate the PET Pot 45° towards you so you can view the bleed needle hole. Insert the bleed needle through the hole and into the vial. Carefully bend the bleed needle away. Rotate an additional 90°.

Step 6

Insert a syringe with a sheathed needle into the syringe shield.

Step 7

Place the syringe shield onto the syringe guider and slide upwards so that the needle goes through the centre of the vial septum. Tighten the screws to hold the syringe shield in place. Withdraw the required dose.

Step 8

Loosen the 2 side screws and slide the syringe shield down the syringe guider. Re-sheath the needle.

Step 9

Place the PET Pot back into its upright position. Remove the syringe guider and replace with the shielded cap.

Lead shielding within PET Pot.